Sprockets, Pulleys and Chains

These sprockets are offset towards the engine case in a stock application, and use a flat rear sprocket. Direct bolt-on for ‘91-’94 models; ‘95-'05 models require a seal and spacer kit # 850-940.

These transmission belt pulleys allow you to change your final drive ratio for faster acceleration or lower RPM cruising on the highway. Installation notes - Changing the final drive ratio will affect speedometer reading; ECM adjustment or a Speedometer Calibration Module may be required to correct reading. Generally speaking, a 1-tooth change can be performed without a belt length change; more than 1 tooth may require changing belt length. Rear axle position adjustment required for each pulley tooth change is +/-.125" (3.2mm), while rear axle position adjustment required for each belt tooth change is +/-.280" (7.1mm). Check axle travel and availability of belts before ordering!

American-Made rear wheel sprockets for 1973-up wheels. Choose from light weight 7075-T6 aircraft quality hardened aluminum alloy or high quality carbon steel. Manufactured in full width for size 530 chain, for maximum strength. Available in dished (.245" offset) or flat for standard Harley® 3.250" bolt circle 5-bolt pattern. 1994-2002 tube-frame Buell 5-bolt pattern available in flat only. Note: if replacing a sprocket provided in a Zipper's chain conversion kit, measure the center hole size of your existing sprocket and order the same center hole replacement. *** Due to supply problems, only aluminum rear sprockets or chrome steel rear sprockets are available!!! ***

This is a sealed chain, lubricated with a special vacuum-injected grease and locked in by durable Nitrile Butadine rubber o-rings, available in metallic silver, gold or black plates with gold pins finish. It has shot-peened and polished link plates, with a tensile strength of 9,000 lbs for long, long life and reduced maintenance