Setting
Currency
0 Item(s)

You have no items in your shopping cart.

Intake Systems

  1. 01
  2. 02
  3. 03
  4. 04
  5. 05
  1. Be the first to review this product

    As low as: $1.45

    S&S carburetor service and rebuilt parts. Available individually. Items marked as "high flow" represent larger, higher capacity inlet seat and needle for use in ‘E’ / ‘G’ and ‘B’ carbs (standard issue in ‘D’ carbs). High flow seat must be used with high flow needle #198-197. Recommended for Racing Use Only In compliance with ARB emissions laws, this product is not sold or shipped to California.
  2. Be the first to review this product

    As low as: $2.25

    Here’s a handy item for race bike use. Quickly disconnect the fuel line for fast carb removal, gas tank removal or gas check sample. High flow design, for use with 5/16” or 3/8” fuel line. Fuel line sold per foot.
  3. Be the first to review this product

    As low as: $2.59

    H-D® changed the intake port configuration, intake manifold mounting flange bolt pattern and throttle body in 2006, which has led to some confusion when adding some factory racing and/or aftermarket intake parts to a given year engine. It is important to use the correct flanges for the cylinder heads you’re using, and the correct seals for the manifold being used. See notes about fitment below. In compliance with ARB emissions laws, this product is not sold or shipped to California.
  4. Be the first to review this product

    As low as: $2.59

    Intake manifold flanges and seals for all Evolution® / 1999-2005 TC, and 2006-up Twin Cam® heads. Flanges for 1984-2005 heads have offset mounting holes; 2006-up flanges are symmetrical (even spacing between the port and mounting holes). The correct year flange must be matched with year of heads being used. These flanges fit standard (1.810” o.d.) and oversize (1.880” o.d.) round port intake manifolds; however, the correct seals must be used for the manifold/port size (oversize round ports use thinner seals). Flanges and standard size seals can be used as stock replacement parts for EV & TC88 engines. In compliance with ARB emissions laws, this product is not sold or shipped to California.
  5. Be the first to review this product

    As low as: $2.95

    Also used as main circuit air bleed jets in modified S&S E & G carbs, and as intermediate circuit air bleed jets in modified S&S B & D carbs. Sold Each. In compliance with ARB emissions laws, this product is not sold or shipped to California.
  1. 01
  2. 02
  3. 03
  4. 04
  5. 05
Loading...
Loading...